Pioneer VSX-LX52 - Manual (Page 92)

Additional information 12
92
En
Positional relationship between speakers
and monitor
Position of front speakers and monitor
The front speakers should be as equidistant as possible
to the monitor.
Position of center speaker and monitor
Since mostly dialogs are output from the center speaker,
keeping the center speaker as close as possible to the
screen makes the overall sound more natural. For TVs
using Braun tubes, however, when installing the center
speaker on the floor, adjust its angle of elevation to point
it towards the listening position.
• If the center speaker is not of the shielded type, install
it away from the TV.
• When installing the center speaker on top of the
monitor, place it facing slightly downwards towards
the listening position.
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Power
TV
L R
45° to 60°
Installation on floor (Diagram as seen
from the side)
Monitor
Symptom Remedy
The power does not turn on. • Make sure that the power cord is plugged in to an active power outlet.
• Try disconnecting from the power outlet, then plugging back in.
Power cannot be turned off.
(ZONE 2 ON or ZONE 3 ON is
displayed.) • Set the remote control’s MULTI-ZONE operation selector switch to ZONE 2 or ZONE 3, then press
 RECEIVER to switch the sub zone off.
The receiver suddenly switches
off or the PHASE CONTROL
indicator blinks. • Check that there are no loose strands of speaker wire touching the rear panel or another set of
wires. If so, re-attach the speaker wires, making sure there are no stray strands.
• The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized
independent service company.
During loud playback the
power suddenly switches off. • Turn down the volume.
• Lower the 63 Hz and 125 Hz equalizer levels in the Manual MCACC setup on page 74.
• Switch on the digital safety feature. While holding down ENTER on the front panel, press
 STANDBY/ON to set this receiver to the standby mode. Use TUNE +/– to select D.SAFETY
OFF, and then use PRESET +/– to select 1 or 2 (select D.SAFETY OFF to deactivate this
feature). If the power switches off even with 2 switched on, turn down the volume. With 1 or 2 on,
some features may be unavailable.
The unit does not respond
when the buttons are pressed. • Try switching the receiver off, then back on again.
• Try disconnecting the power cord, then connect again.
VSX-LX52_SVYXJ.book 92 ページ ２００９年２月２６日 木曜日 午後４時３１分