Panasonic PV-C1323A - Manual (Page 26)

26 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Tape Operation
(continued)
Repeat Play
Set to see a recording over and over.
1
2
1) Press to
select
“REPEAT
PLAY.”
2) Press to
set REPEAT
PLAY “ON” or
“OFF.”
3
M A I N MENU
T V VCR
EX I T CLOCK C H
LANGUAGE
SET : ACT I ON
SELECT :
1) Press
to select “VCR.”
2) Press
ACTION to
display SET
UP VCR
screen.
Press ACTION to display
MAIN MENU.
4
Press ACTION twice
to end setup.
Zero Search
To quickly return to a specific tape counter location.
1
2
Press STOP.
4
5
3 Continue playback, rewind, or
fast forward.
Press COUNTER
RESET at the
desired position to
reset to “0:00:00.”
• Unit goes into FF or REW mode and stops at
the last point the Counter was set to 0:00:00.
Press DISPLAY during playback to
display the Counter.
• Playback repeats when tape end is reached or
unrecorded portion over 30 seconds is detected.
• During playback, you may also press PLAY/
REPEAT repeatedly on the unit to select
REPEAT “ON” or “OFF.”
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
• : Present position mark
: Zero position mark BEG I N END
1 : 23 : 45
BEG I N END
0 : 00 : 00
• If a blank portion exists on the tape, and
depending on the position of the mark, the
mark display may be out of position.
Notes
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
Commercial Skip
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
1
Note
REPEAT REPEAT PLAY PLAY : OFF FF
T I MER PROGRAMMING
SELECT :
SET :
END : ACT I ON
SET UP VCR