Advanced operation, Tape operation, Program end search – Panasonic PV-C1323A User Manual
Page 24: Index search, Search system is
24
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Search System is ...
Each time a recording is made, an invisible index mark is placed on the tape.
When timer recordings are made, program index and information are also included.
These index marks can be used to access or scan recordings.
Tape Operation
Program End Search
1
SEARCH START
:
FF
EX I T
:
SEARCH
PROGRAM END SEARCH
Example of
Program End Search
operation.
Fig.1
Fig.2
Fig.3
If search exceeds a few seconds in BLANK area.
Program 2
BLANK
Program 1
INDEX
Press SEARCH button
FF
2
Press SEARCH button
Index Search
Go directly to the desired recording.
• Make each entry within 10 seconds, or the Index
Search mode will be canceled.
• If Index Search is started very close to an index
mark, that index mark may not be counted in the
search.
Notes
NOTE: indicates start points of each recording.
■
■
■
■
■
To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
6
1
5
7
2
3
4
1
7
5
3
4
6
2
Press SEARCH
twice in Playback
or Stop mode to display
PROGRAM END SEARCH screen
.
Press FF
to
start search.
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.
Locates end point of recording for continuity.
End Point
Notes
PLAYBACK DIRECTION
Program 1
Program 2 or BLANK
INDEX
Press SEARCH button
FF
End Point
Program 2
BLANK
INDEX
BLANK
Program 1
Press SEARCH button
FF
End Point
1
2
Press SEARCH*
in Playback or
Stop mode to
display INDEX
SEARCH screen,
and then
press
NUMBER Keys
to
select the
recording number.
To calculate number,
•
see below.
Press FF
or
REW
to start search.
Play begins at
search end. To
search forward or
back 1 index,
press FF
or
REW
while screen left in
displayed (10 sec.).
ENTER I NDEX NUMBER : 1
US I NG 1- 9 KEYS
FORWARD SEARCH
:
FF
REVERSE SEARCH
:
REW
NEXT
:
SEARCH
EX I T
:
STOP
I NDEX SEARCH
FORWARD SEARCH
:
FF
REVERSE SEARCH
:
REW
I NDEX SEARCH