Panasonic DMC-FX1GN - Manual (Page 93)

Playback (advanced)
93
ª When using Windows 2000 Professional, Windows Me,
Windows 98/98 SE or Mac OS 9.x
• When connecting the camera to a PC, do not set [USB MODE] to [PTP].
(When the camera is shipped, [Mass Storage] is selected.)
• When using Windows 98/98 SE, install the USB driver before connecting. (When
using Windows Me/2000/XP, Mac OS 9.x and Mac OS X, you do not have to install
the USB driver.)
• When connecting to the PC which includes the
above-mentioned OS with setting the [USB MODE] to [PTP],
the messages shown on the right appear on the LCD
monitor of the camera.
The following messages appear for each OS on the display of the PC. Select
[Cancel] to close the window and disconnect the PC.
PTP
USB MODE
OS Message
Windows 2000 Professional [Welcome to the Found New Hardware
Wizard]
Windows Me
Windows 98/98 SE [New Hardware Found] >
[Add New Hardware Wizard]
(When you connect to the PC more than
2 times, only [Add New Hardware Wizard]
appears.)
Mac OS 9.x [Software needed for the USB device
“DMC-FX5 or DMC-FX1” is not available.
Would you like to look for the software on the
Internet?]
FX5_FX1-GN.book 93 ページ ２００３年１２月１７日 水曜日 午前９時２０分