Panasonic KX-FP86 - Manual (Page 57)

Erases a specific message
Erases all messages
Changes to the TEL mode
Turns ON message transfer
Turns OFF message transfer
Turns ON pager call
Turns OFF pager call
57
Remote Operation
Remote command
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (feature #11 on page 63) and set the unit to the TAD/FAX
mode before going out (p. 50).
Dial key Page Dial key Remote command Page
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
Stops re-recording of a greeting
message
9
7
6
5
4
2
1
0 59
58
58
58
58
59
59
59
8 4
8 3
8 2
8 1
8 0
5
4 59
59
59
59
59
59
59
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Answering Device
Remote Operation
Notice of Remote Operation
Fold here
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
● The new messages will be
played automatically.
● If there are no new
messages, wait for 4
seconds. All the messages
will be played back.
3. Press the remote command
key(s) within 10 seconds (see
the reverse side).
● The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
● When the unit is in the TEL
mode, call your unit and wait
for 15 rings. The answering
device will temporarily answer
the line. Enter the remote
operation ID during the
greeting message. The unit will
switch to the TAD/FAX mode.
● When you press a key, press
firmly.
● To send a document, press
. When a fax tone is
heard, start transmission.
9
Operating from a remote location !