beautypg.com

Using the cable cover, Using the remote terminal, Pin assignment and control – Panasonic PT-L780E User Manual

Page 28

background image

E

NGLISH

-55

Ad

v

a

nced

Operation

54-E

NGLISH

Using the cable cover

When installing the projector to the ceiling, the accessory cable cover can be
used to cover the terminals or cords after removing the cut-away parts.

'Tighten the screw by turning it

clockwise.

$Work the cut-away parts back and

forth several times to break the
fixing tabs. Smooth off any jagged
edges if necessary.

#Use pliers or similar to break the

perforated sections of the cut-
away parts.

%Pass the power cord through cut-

away part S, and pass the other
cables through cut-away part L,
and then insert the tabs of the
cable cover into the mounting
holes in the projector.

&Push hook 2 until it locks into

place.

Perforated sections

Hook2

Hook1

Fixing tabs Fixing tabs

Cut-away part S

Screw

Cut-away
part L

Refer to page 53 for details on
removing the cable cover.

NOTE:
Do not cover the air inlet ports when
using the cable cover as stated
above.
Do not place any heavy objects on
the cable cover to prevent it from
being removed.
Do not bend the cables greatly,
otherwise it will be difficult to attach
the cable cover.
Remove the cable cover when
cleaning or replacing the air filter.

Using the remote terminal

Using the remote terminal built into this projector, it is possible to operate the
projector from an external location from where infrared remote control signals
cannot be received, by using a remote control panel.

Pin assignment and control

Short pin 1 and pin 9 when controlling.

#Power ON/OFF

D-Sub 9-pin (female)
external appearance

NOTE:
B The POWER, RGB and VIDEO buttons on the remote control unit and

projector will not operate when pins 1 and 9 are shorted. RS-232C
commands will also be ignored. If the projector is connecting a personal
computer using an optional wireless card or LAN card, the “POWER” or
“SWITCH INPUT MODE” will not function.

B Do not short pins. 1, 2, 3, 5, or 6 when pin 9 is open. If this is done, the

projector will ignore signals from the remote control unit.

Pin

#
$
%
&
'
(
)
*
+

Signal Name

GND

POWER

INPUT SEL3

INPUT SEL1

INPUT SEL2

ENABLE

Description

Ground

Power ON

Input signal select3

NC

Input signal select1

Input signal select2

NC

NC

Enables remote terminal control

1

5

6

9

Pin No.

Setting

Short

Open

OFF (standby)

ON

$-#

Lamp

Pin No.

Setting

Open

Open

Short

Short

Short

Open

Open

Short

Open

Open

Short

Open

Open

Open

Short

Open

Open

Short

RGB1

RGB2

RGB3

VIDEO

S-VIDEO

DVI

%-#
'-#
(-#

Input Signal

$Switching the input mode

This manual is related to the following products: