Precor p80 - Manual (Page 21)

Getting Started
19
Using the Treadmill Safety Clip
The treadmill is equipped with two different stop functions,
which behave as follows:
If the user … Then the
treadmill belt …
And the console …
Presses down on the red
STOP button
Slows to a stop Shows that the exercise
workout is paused
Pulls on the lanyard
attached to the safety
clip and trips the restart
switch
Slows to a stop Shows the words PUSH
TO RESET SWITCH
and an arrow pointing
to the Restart switch
The restart switch is located just below the console and
immediately behind the red STOP button, as shown in the
following figure. When it is tripped, the bar pops up,
displaying the words PUSH TO RESET SWITCH on its front
side. The treadmill does not operate while these words are
visible.
Figure 5: Restart switch
Instruct users on how important it is to use the safety clip
while exercising on the treadmill, and demonstrate how they
should attach it to their clothing near the waistline.