Pioneer DVR-745H-S - Manual (Page 41)

Recording 05
41
En
G-Code programming with the
power off
You can enter a G-Code programming
number when the recorder is in standby.
Note that the recording is always made to
the HDD. If you want to record to a DVD disc,
you’ll need to switch on the power and use
the full G-Code program screen.
Important
• You can’t use this feature until you have
set up the guide channels. See G-Code
CH Setting on page 107.
• You can’t change the recording mode.
• You can’t program daily or weekly timer
recordings.
1 Press ’G-Code’.
The front panel display shows the current
recording mode and prompts you to enter
the G-Code programming number.
2 Use the number buttons to enter the
number.
• To clear the last digit entered, press
CLEAR .
3 Press ENTER.
The display shows the timer settings:
Date
Start time End time HDD and
Recording channel Recording mode.
• If CODE ERROR appears in the display,
check that the number is correct and
that the guide channel is set (see
G-Code
CH Setting on page 107), then set the
timer recording again.
• If CAN’T SET appears in the display, it
means that although you entered a valid
number, the program has already
finished.
Setting a manual timer recording
The timer recording screen you can see all
the timer programs already set, clear
programs and set up new ones.
1 Press TIMER REC to display the Timer
Recording screen.
You can also access the Timer Recording
screen from the Home Menu (press
HOME
MENU , select Timer Recording , then Timer
Recording ).
This screen shows all the timer programs
currently set.
• Each row is for one timer recording
program, with the date and time
information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on
the HDD and the currently loaded
recordable DVD is shown towards the
bottom of the screen.
• In the upper-right corner, the number of
timer programs already set is shown
next to
Tmr Pgms .
• If there are more than five timer
programs already set, press NEXT
to switch page (go back using the
PREV button).
• You can also delete a timer program
before it’s started (before the recorder
enters timer recording standby) by
highlighting it and pressing
CLEAR . See
also Deleting a timer program on
page 43.
HDD Remain
DVD Remain 59h59m(SP)
1h59m(SP)
3/26 SUN 3:00PM
Tmr Pgms 3/32
Manhattan Open Tennis OK
3/26 SUN 6:00PM – 7:00PM 10ch
World Journey OK
3/27 MON 7:30PM – 9:00PM 4ch
8ch
Flower Until 4/20
MON – FRI 1:30PM – 2:00PM
New Input
Timer Program View
DVR745H_IBD_EN.book 41 ページ ２００６年７月２７日 木曜日 午後４時１１分