Philips FW930SR - Manual (Page 11)

11
English
Easy Set
EASY SET allows you to store all available
radio stations and RDS stations
automatically.
1 Press and hold STANDBY ON (on the
system only) for 5 seconds; when the
system is in standby or demonstration
mode.
™ “EASY SET” will be displayed,
and followed by “ TUNER” and then
“ AUTO”.
™ EASY SET will start searching for all
radio stations with RDS and then
followed by radio stations on FM,
MW and LW band respectively.
™ All available RDS and radio stations
with sufficient signal strength will be
stored. Up to 40 presets may be
stored.
2 The system will proceed to set the RDS
time automatically with the stored RDS
preset station.
• If no RDS station is available in the first
preset station, the program will exit
automatically.
™ After a radio station is found,
“ EASY SET” will be displayed
and followed by “ TIME”
• When searching RDS time;
™ “SEARCH RDS TIME” will be
displayed.
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
mode, the demonstration will resume 5
seconds later.
To stop the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only) for 5 seconds when
the system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
Note:
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only) for 5 seconds when
the system is in standby mode.
™ The demonstration will begin.
OPERATING THE SYSTEM
™ When RDS time is read, “RDS
TIME” will be displayed. The
current time will be displayed for 2
seconds and stored automatically.
Notes:
– EASY SET will start with the RDS
station, if there are still presets
available, it will continue to store the
FM, MW and LW bands respectively.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station or the first
available RDS station will appear on the
display when EASY SET is completed.
– If RDS station does not transmit RDS
time within 90 seconds, the program
will exit automatically and the display
will show “NO RDS TIME”.
Switching the system ON
• Press STANDBY ON (on the system
only), CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
FRONT FM
STEREO
BACK HSD REC
LW MW AM T.A. NEWS
SOUND NAVIGATION
INCREDIBLE
SURROUND DYNAMIC BASS
BOOST
TAPE CD
PROG
CLOCK/
TIMER
DOLBY B
NR
DUB
(HSD)
REC
SIDE A•B
TUNER AUX
PRESET ▲ ▲
STOP•CLEAR SEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
C D 1 • 2 • 3 CDR BAND TAPE 1 • 2
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
VOLUME
SHUFFLE PROGRAM
DIGITAL
SOUND CONTROL
REPEAT
A. REV
STANDBY
ON
RDS
A. REV
MIC
MIC
LEVEL
NEWS/TA
RDS