Polaroid Polaview 220 - Manual (Page 36)

Symptom Cause Solution
Solid-color screen is Projector is initializing If screen is displayed for
displayed more than 15 seconds,
press a source button
associated with an active
source
Lamp does not light, Unit is in Standby mode Wait approximately
green LED on rear and bulb-restrike timer 3 minutes, if bulb does not
control panel is flashing has not elapsed light press the LAMP key
Image is not in color Incorrect computer video Reboot your computer
No projected image Improper cables/ Check for proper cables
loose cables and snug connection
CURTAIN (blue display) Press the CURTAIN key
is on
Active light source is not Verify proper connection
selected and press source key
associated with
an active source
Video source has not Common problem with
been activated laptop computers, contact
your computer dealer
Where to get help
If at any time you need help:
1 Check the Troubleshooting guide .
2 Call your dealer’s technical support line and explain your
problem.
3 Call Polaroid Corporation (see pages 35 and 36).
Please have the serial number of your unit (located on the
underside of the projector) available when you call.
34 Troubleshooting