Polaroid Polaview 220 - Manual (Page 31)

True-to-life color Examine the projected image for true-to-life color rendition.
rendition Use the TINT option to make the adjustments:
1 From the projector control panel or remote control, press
the IMAGE menu key.
2 Using the cursor pad, scroll through the menu selections
and highlight TINT on the on-screen menu display.
3 Use the left (<) and right (>) arrow keys on the cursor pad to
adjust the color balance of the projected image.
Restoring factory If desired, you can restore the original factory settings by
settings selecting the SETUP menu key, using cursor pad to select
the RESET option, and depressing the right arrow key. Any
changes from the default setting are stored in memory for
that source.
Note: If for any reason the projector should not respond to
the control panel or remote control commands, you can
reset it by performing the following steps:
1 Turn off the unit and allow it to cool for at least 3 minutes.
2 Press the SET UP key on the projector control panel and
turn on the projector as you continue pressing the SET UP
key. Continue to press the SET UP key until the LEDs of the
SOURCE 1–4 keys on the control panel light up red and
green.
3 Release the SET UP key.
4 Reconfigure the projection settings for rear projectors, ceil-
ing mount, as required.
28 Using the projector