Polaroid Polaview 220 - Manual (Page 18)

3 Connect the white RCA audio-video cable plug to the
AUDIO L (left) jack of your audio source. Then connect the
white plug at the projector end of the cable to a white audio
jack (either SOURCE 1 or SOURCE 2 L) on the projector rear
panel.
S-video connections
Note: Whenever you connect the projector to a computer or
video source for the first time, the projector defaults to the
factory settings. Due to operational differences between
computers and video sources, it may be necessary to make
minor adjustments to the settings. See
Image optimization
in Chapter 4, Using the projector for more information.The
projector stores any modified settings and defaults to them
when you turn the power off and on again.
14 Detailed setup
Yellow
(not
connected)
Red
White
L R
SOURCE 1
VIDEO INPUTS
L R STEREO
MAC / PC
STEREO
PC / MAC
STEREO
REDRIVE
L R
RS 232
SOURCE 2 SOURCE 3 SOURCE 4 OUTPUTS
COMPUTER INPUTS
Use SOURCES 1 and 2 to connect
more than one audio/video device
(one cable per device)
Audio/Video cable
S-VHS cable
VCR or laser disk player
AUDIO
L R
VIDEO S-VIDEO
Yellow
(not
connected)
Red
White
SOURCE 2
SOURCE 1