Precor 300753-201 - Manual (Page 20)

18 Operating and Maintaining the P20 Console
On self-powered equipment, the battery initializes when you
begin working out. You must maintain a minimum rate of
motion for the Welcome banner to appear. PEDAL FASTER
(or the equivalent message depending on the equipment
type) appears in the display when the battery is low or when
the rate of motion drops below the minimum requirements.
Viewing the Odometer Informational Menu
Each piece of equipment provides information about its use,
as well as its software version, serial number, usage log, and
event log. In most cases, you will only access this information
if directed to do so by Precor® Customer Support.
To view the odometer informational menu:
1. Press the following keys in the order presented.
Reset (Pause/Reset on tread consoles)
Input Up
Enter
Note: Only two seconds are allowed between keypresses.
If a key is not pressed, the console display returns to the
Welcome banner.
2. Press Up or Down to navigate the menu.
3. Press GO to select a test.
4. Press Programs once to return to the Odometer menu or
twice to return to the Welcome banner.
Odometer
The odometer tracks equipment usage by the number of units
traveled. The Odometer Units and Values table provides
information on how usage is tracked depending on the
equipment type.
The odometer information updates under these conditions:
 Every 30 minutes
 At the end of a course
 When an event occurs
If the course is terminated by turning off the power, then the
odometer data for that workout is lost.