Planet Technology VIP-101T - Manual (Page 20)

PLANET VIP-101T CLI configuration
- 14 -
seen with this command.
Syntax Description
-print Display PPPoE device information.
Default
This command has no default value.
Example
b) –dev
Parameter –dev can be used to enable or disable PPPoE function.
Syntax Description
-dev Enable(=1) or Disable(=0) PPPoE function in VIP-101T
Default
0 PPPoE function in VIP-101T is turned off.
c) –open
While VIP-101T is not in PPPoE connection state, you may use parameter –open to
initiate a PPPoE connection.
Syntax Description
-open Initiate a PPPoE connection.
Default
This command has no default value.
d) –close
While VIP-101T is in PPPoE connection state, you may use parameter –close to
disconnect a PPPoE connection.
usr/config$ pppoe -print
PPPoE adapter information
Device : Disable
Status : Not initialized
User name : pppoe
Password : *****