Philips 21PV708-715-908-918/39 - Manual (Page 22)

c Press C .
TIMER PROGRAMMING
VPS
DATE PROG. START END LP PDC REP.
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
15 xxx 15:36 15:50 - * ONCE
Store:
press OK
d Select the entry field ’ PROG. ’ with the D or C
button. Select ’ Record prepared ’ with the B or
A button.
e Confirm with the OK button.
Your TV-VIDEO Combi is now prepared for recording. The
start and end of the recording is controlled via the scart
cable.
f To end, press the TIMER s button.
g Place a cassette in the machine.
E If you have not connected the satellite receiver yet, use a
scart cable to connect scart socket EXT. 1 on the
TV-VIDEO Combi to the corresponding scart socket on
the satellite receiver.
h Programme the satellite receiver with the required
information (programme number on the SAT receiver,
start time, end time).
D The information on how to programme your satellite
receiver can be found in the instruction manual for
your satellite receiver.
Activating a recording from the SAT
receiver with OTSR (OTSR = One Touch Sat
Recording)
In the previous paragraph we described how to prepare the
TV-VIDEO Combi for recording from the SAT receiver by
means of the menu (step
a through f ). OTSR will allow
you to record a SAT programme fast and easy with just one
button press.
a Press the Sr/q buttons at the same time until the
timer light on your TV-VIDEO Combi starts blinking. It will
blink three times and will then stay alight.
Your TV-VIDEO Combi is now prepared for recording. The
start and end of the recording is controlled via the scart
cable.
D Each time you programme a recording on the
satellite receiver, you must prepare your TV-VIDEO
Combi for recording. Each time you prepare your
TV-VIDEO Combi for a satellite recording a
TIMER-block will be reserved and the TIMER light at
the front will blink.
D If the TIMER light does not blink, you have not set
the clock or all TIMER-blocks have been used up.
Please read the paragraph ’Setting the time and
date’ or ’How to clear a programmed recording
(TIMER)’.
D If you want to cancel the programmed SAT
recording, follow the procedure described in the
paragraph ’How to clear a TIMER’.
How to check or change a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’ TIMER PROGRAMMING ’ with the
menu buttons B or A and confirm with the C
button.
c Select the TIMER you want to check or change with the
B or A button and confirm with the OK button.
d Select the entry field with the D or C button.
e Change any information with the B or A button or
with the 0-9 buttons.
D Under ’
LP ’, use the B or A button to select the
recording speed ’SP’ or ’LP’.
f Confirm with the OK button.
g To end, press the TIMER s button.
h Make sure that the cassette you have put in can be
recorded on.
How to clear a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’ TIMER PROGRAMMING ’ with the
menu buttons B or A and confirm with the C
button.
c Select the TIMER you want to clear with the menu
buttons
B or A .
d Press the CLEAR button.
e Switch off with the TIMER s button.
20