Pioneer DEH-1400RB - Manual (Page 10)

En 9
RDS
Receiving traffic announcements
TA (traffic announcement standby) lets you
receive traffic announcements automatically,
no matter what source you are listening to. TA
can be activated for both a TP station (a station
that broadcasts traffic information) or an
enhanced other network’s TP station (a station
carrying information which cross-references TP
stations).
1 Tune in a TP or enhanced other network’s
TP station.
When you are tuned into a TP or enhanced other
network’ s TP station the
TP indicator will light.
2 Press TA to turn traffic announcement
standby on.
Press
TA and the TA indicator appears in the
display. The tuner will standby for traffic
announcements.
• To turn traffic announcements standby off,
press
TA again.
3 Use VOLUME to adjust the TA volume when
a traffic announcement begins.
When you press
VOLUME up/+, the volume is
raised and when pressed down/–, the volume is
lowered.
The newly set volume is stored in memory and
recalled for subsequent traffic announcements.
4 Press TA while a traffic announcement is
being received to cancel the announcement.
The tuner returns to the original source but
remains in the standby mode until
TA is pressed
again.
Notes
• The system switches back to the original
source following traffic announcement recep-
tion.
• Only TP and enhanced other network’s TP
stations are tuned in during seek tuning or
BSM when TA is on.
Responding to the TP alarm
When a TP or enhanced other network’s TP
station is lost due to a weak signal the
TP indi-
cator is extinguished and a series of short
beeps, about five seconds long, sound to
remind you to select another TP or enhanced
other network‘s TP station.
When listening to the tuner, tune in another
TP or enhanced other network’s TP station.
• When listening to sources other than the
tuner the unit will automatically seek out a TP
station with the strongest signal after about 10-
or about 30-second delay. The delay is about 10
seconds if TA is on and 30 seconds if TA and AF
are on.