Configuring the lan, Enable/disable dhcp – Paradyne 6388 User Manual

Page 43

Text mode
Original mode

3. Using the Web Interface

6388-A2-GB20-00

February 2005

3-19

Configuring the LAN

To configure LAN parameters, click on Setup on the Home screen. Under LAN
Setup, click on LAN Configuration. The LAN Configuration screen appears.

Enable/Disable DHCP

By default, your CPE has DHCP server (LAN side) disabled. If you already have a
DHCP server running on your network, do not enable a second DHCP server.

To enable DHCP:

Procedure

1. From the Home screen, click on Setup.

2. Under LAN Setup, select LAN Configuration. The LAN Group 1 Configuration

screen appears.

Figure 3-15. LAN Group 1 Configuration

3. The DHCP server is enabled when “Enable DHCP Server” is selected. If you

enable it:

— Specify a Start IP address. The Start IP Address is where the DHCP

server starts issuing IP addresses. This value must be greater than the
router's IP address value. For example, if the router's IP address is