Paradyne 6388 User Manual

Page 37

3. Using the Web Interface

6388-A2-GB20-00

February 2005

3-13

7. Select the encapsulation type (LLC or VC). If you are not sure which to use,

just use the default mode.

8. Select the quality of service (QOS). Leave the default value if your ISP did not

provide this information. Depending on the QoS you select, you may also
enter:

— PCR (Peak Cell Rate)

— SCR (Sustainable Cell Rate)

— MBS (Maximum Burst Size)

— CDVT (Cell Delay Variation Tolerance)

If your DSL line is connected and your DSL provider is supporting DHCP, you can
click on the Renew button and the CPE will retrieve an IP Address, Subnet Mask,
and Default Gateway address. At any time you can renew the DHCP address by
clicking on the Renew button.

Figure 3-10. DHCP Connection Setup

To complete the connection you must now click the Apply button. The Apply button
will temporarily save this connection. To make the change permanent, click on
Tools (at the top of the page) and select System Commands. At the System
Commands page, click on Save All.