Philips VR620/58 - Manual (Page 45)

41
3
Enter the entire ShowView number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g. 5-312-4 or 5 312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with CLEAR
(CL)
.
SHOWVIEW
SHOWVIEW NUMBER REP.
53124---- èONCE p
________________________________
REP.pSELECT
STOREpOK
TIMER LISTpTIMER
Selecting onetime/daily/weekly recordings
Using SELECT , select from the following options:
'ONCE': Recording once
'MO-FR': Repeated daily recordings (Monday to Friday)
'WEEK.': Repeated weekly recordings (every week on the same day)
4
Confirm with OK .
TIMER
VPS
DATE REP. PROG. START PDC END
21 MO-FR 01 20:00 ] 21:30
________________________________
REP.pSELECT
STOREpOK
aThe following message appears on the screen: 'SELECT PROG.
NR.'
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Using the number buttons 0..9 on the remote
control, select the corresponding programme number (name) of the TV
channel and confirm with
OK .
aThe following message appears on the screen: 'SHOWVIEW NUMBER
NOT VALID'
b The entered ShowView number is incorrect. Correct your instructions or
end with MENU .
b Check the time/date (see chapter 'Installing your video', section 'Setting the
time and date').
aThe following message appears on the screen: 'MO-FR
PROGRAMMING NOT POSSIBLE FOR WEEKEND'
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
5
The decoded data appears after confirmation. You can go back to
change the data. Select the corresponding input field using P or
Q . Change the data with ;qP , P r= or with the number
buttons 0..9 .
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using P . Using SELECT switch on
'VPS/PDC' (']' lights up). If you press SELECT again, you will switch
'VPS/PDC' off (']' goes out).
6
When all informations are correctly, confirm with OK . The
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
ENGLISH
Programming a recording (TIMER)