Philips VR620/58 - Manual (Page 22)

18
Automatic TV channel search
During installation, all available TV channels are searched for and saved. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the video
recorder, e.g. after moving house, you can start this procedure again. This will replace the TV
channels already saved with the new ones.
1
Switch on the TV set. If required, select the programme number for
the video recorder.
2
Press the MENU button on the remote control. The main menu will
appear.
3
Select line 'AUTO TUNING' using P r= or ;qP .
4
Press OK .
AUTO TUNING
SEARCHING
00 TV CHANNELS FOUND
ƒƒƒƒƒƒƒ__________________
PLEASE WAIT...
5
The automatic TV channel search starts. This allows the video
recorder to save all available TV channels. This procedure may take
several minutes.
6
When the TV channel search is complete, 'STORED' will briefly appear
on the TV screen.
7
To end, press MENU .
You can read about how to search for a TV channel manually in the section 'Manual TV channel
search'.
Monitor function
You can switch back and forth between the TV picture and video recorder picture with
MONITOR . But this only works when you use a scart cable to connect the video recorder to
your TV set and your TV set responds to this switch-over.
Installing your video recording