Polaris Sprotsman 700 - Manual (Page 66)

64
OPERATION
Starting the Engine
Procedure for Starting a Cold Engine
1. Place the transmission in
neutral or park and reset the
parking brake.
2. Turn the fuel tank valve to ON.
3. Sit on the vehicle.
4. Pull the choke out all the way.
5. Turn the engine stop switch to
RUN.
6. Turn the ignition key past the
“ON” position to engage the
starter.
NOTE: the choke is on “FULL” when the knob is pulled out all the
way. The choke is “OFF” when the knob is pushed in. This is a
variable choke and can be adjusted gradually, depending on how much
choke is needed for starting.
7. Do not press the throttle while starting the engine.
8. Activate the starter for a maximum of five seconds, releasing the
key when the vehicle starts. If engine does not start, release the
starter and wait five seconds; then activate the starter for another
five seconds. Repeat this procedure until engine starts.
Never run an engine in an enclosed area. Carbon monoxide
exhaust gas is poisonous and can cause severe injury or death.
Always start engines outdoors.
WARNING
You must allow your vehicle adequate warm up time before
operating or engine damage could result.
CAUTION