Philips 9P5540C1 - Manual (Page 44)

STOP ■
REW
ᮤᮤ
FF
ᮣᮣ
PLAY ᮣ REC• STATUS
VOL CH
1 2 3
4 5 6
7 8 9
0
ON/OFF
TV/VCR
VCR ACC TV
SWAP FREEZE POS
SIZE
ENTER
MENU
M
CLEAR
؀ ؁
SURF MUTE
PAUSE II
SLEEP
SMART
POWER
M O D E
2 TUNER PIP
B ᮤ ᮤ A
06
07
08
09
06
07
08
09
1
3
4
2
4
2
06
07
08
09
S
ETTING THE
R
EMOTE
T
O
W
ORK
O
THER
D
EVICES
- S
EARCH
Y our TV remote can be set to
work various accessory
devices (VCRs, Cable Converters,
Satellite Receivers) by what is
called the SEARCH method.
Note: The Search Method only
works with devices equipped with
Channel Display Indicators or
capability. If the "Direct Access"
code number method (shown in
the previous section) did not set
your remote to work your
accessory device, then follow the
easy steps listed below.
Turn ON the desired device.
Press the correct VCR or ACC
system button on the remote.
Stand at least six feet away
from the front of the accessory
device. Point the remote toward
the unit. HOLD DOWN the
SURF and the desired System
(VCR or ACC) buttons at the
same time. KEEP HOLDING
BUTTONS DOWN.
Watch the Channel Indicator
on the unit. Channel Numbers will
SCAN UP when the unit has been
identified. This may take up to
two minutes.
Release the SURF and System
(VCR or ACC) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the accessory device.
STOP
1
2
3
4
VCR
Don't let the Accessory Device
scan up more than five channels
(in Search mode).
Six Feet
(minimum )
S MART H ELP
Remember, a minute or two
can seem very long, but the
code should be located within two
minutes.
Don't let the accessory device scan up
more than five channels. The remote
may pass up the right code and another
two minute search cycle will have to
be repeated.
If no channel change happens within
two minutes, repeat steps 1-4. Should
a channel change still not occur, the
remote will not work with the desired
unit.
BEGIN
CABLE TV
CONVERTER
44
SEARCH METHOD
SATELLITE RECEIVER