Connecting – PYLE Audio PLDVD170 User Manual

Page 13

Connecting

Press

AMP SEL

to select

the mode

you need

Using the speaker cables

Connecting PURPLE with white

stripe cable to the Remote eye

jack on the rear of Amplifier,

or using the Audio / coaxial cable

Any connection mode

AMP Select

Press AMP SEL button on the remote repeatedly, select the amplifier mode
you need ( depending on the connection mode).

AMP mode

Note: Setting to ALL, the player will be in high consumption.

So we advise to select the right mode for your connection mode.

A AP On

A AP OFF

E AP On

I AP On

Connecting the Audio cable to

the monitor or audio system

(refer to page 9)

Connection mode

Display on pannel

NOTE 1

1)THE DVD PLAYER USES 12V DC AND THE COVER IS GROUNDED.

2)THE DVD PLAYER HAS A HIGH-POWER 4 CHANNEL BUILT IN AMPLIFIER.

THE SPEAKER CABLES USED MUST BE A MINIMUM OF 18 GAUGE CABLE,

IF ONLY CONNECTING 2 SPEAKERS, YOU MUST CONNECT THE 2 FRONT

SPEAKERS (F , F ) OR 2 REAR SPEAKERS (R , R ).

3) THE UNUSED SPEAKER CABLES MUST BE PROPERLY INSULATED WITH TAPE OR

TERMINATING CONNECTORS TO AVOID A SHORT.

NOTE 2
1 Refer to the owner's manual for the connected monitor as well.
2 Connect the DVD video player to your monitor directly. If you connect the DVD player to a

VTR, TV/VTR combination or video selector, the playback picture may be distorted as DVD
discs are copy protected.(refer to NOTE ON LOCATING )

NOTE 3
1 Refer to the owner's manual of the connected equipment for additional information.
2 When you connect the DVD player to other equipment, be sure to turn off the power .
3 If you place the DVD near a tuner or radio, the radio broadcast sound might be distorted.

In this case, place the DVD player away from any other tuner or radio.

4 The output sound of the DVD player has a wide dynamic range. Be sure to adjust the

receiver's volume to a moderate listening level. Otherwise, the speakers may be damaged by
a sudden high output.

5 Turn off the amplifier before you connect or disconnect the DVD player's power leads.

If you leave the amplifier power on, the speakers may be damaged.

Note on Connecting