PYLE Audio PLDVD170 - Manual (Page 10)

7
When using remote control
Preparing the remote control
1) Open the cover,
pull the cover as illustrated 2)Insert cell (3V),Close the cover
Insert the batteries into the remote control so you can use it to operate the DVD video player.
Do not expose the remote sensor of the DVD player to a strong light source such as direct
sunlight or other illumination. If you do so, you may not be able to operate the DVD player via
the remote control.
Make sure to match the +and - on the lithium button cell(3V, CR2025) to the marks inside the
cell compartment.
Operating with the remote control
1)This section shows you how to use the
remote control. Point the remote control
at the remote sensor and press the buttons.
The remote range: about 4m from the front
of the remote sensor.
(Is) off axis: more than 30 in each direction
of the front of the remote sensor.
2) Remote sensor and remote control eye jack
Connect the remote control eye jack to the
remote sensor unit.
L
Not used when using the remote sensor
on the remote control eye jack.
Double-side tape
Remote sensor
DVD player
Remote eye jack
With about 4m
Notes on battery
Notes on the remote control
To operate the remote control correctly, follow the instructions below.
Do not insert cell into the remote control in the wrong direction.
Do not charge, heat, open, or short-circuit the cell. Do not throw cell into a fire.
If the remote control does not function correctly or if the operating range becomes reduced,
replace all cell with new one.
Direct the remote control at the remote sensor of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.