Pella Precision Fit - Manual (Page 7)

5
EXTERIOR SEAL
A. Place a corner bead of sealant at the jambs and head
connecting the existing frame and the replacement
window frame.
Caution: DO NOT seal the bottom exterior to allow for
incidental water to weep.
5A
1”
5B
Sill
5A
B. Optional: Place a bead of sealant where the sill
adapter meets the sill. If sealant is placed on the sill
leave at least 1” of sill adapter unsealed at each end.
This sill allow for incidental water to weep.
POCKET REPLACEMENT
'Ž ƚŽ ƉĂŐĞ ϭϭ ĂŶĚ ϭϮ ĨŽƌ /ŶƚĞƌŝŽƌ ĂŶĚ džƚĞƌŝŽƌ &ŝŶŝƐŚŝŶŐ /ŶĨŽƌŵĂƟŽŶ͘
FIXED WINDOW REPLACEMENT:
FIXED WINDOW REPLACEMENT
6
FIXED SASH REMOVAL
INTERIOR SASH STOP
1A
Interior
sash stop
1A
1A
Note: Confirm the opening and window dimensions prior to removing the
existing window sash.
A. Score paint or varnish along
interior sash stops with sharp
utility knife. Carefully remove the
interior sash stops at jambs (sides)
and head (top) using a putty knife
and pry bar. Set aside for reuse.
B. Remove the old sash. Remove
other trim, stops, flashing or
brickmould as required.
6A
6A
C. Clean opening thoroughly and repair or replace any rotted or
damaged framing if required.
Note: The end result should be a clean flat uninterrupted surface
on the bottom, top and sides of the opening where the new window
will be installed.
D. Test fit the window, make any adjustments to opening as needed.
6A