Philips CEM3000B User Manual
Page 10
11
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Turn on
1
Press to turn on the unit.
To turn off the unit, press and hold
•
for a few seconds.
Set clock
1
Press
MENU.
2
Press /
repeatedly until [CLK SET]
displays.
3
Rotate to set hour.
4
Press to confirm.
5
Rotate set minute.
6
Press to confirm.
1
Find a location as flat as possible on the
outside of your car. For example, the roof
near the windshield, or rear window.
Note: The magnetic base of the
antenna will remain secure at normal
vehicle speeds in non-windy conditions.
Antennae installed on curved surfaces
may become detached in windy
conditions.
2
Make sure the selected surface is
clean and free of dirt, water, or other
substances which could inhibit attachment
to the surface.
3
Gently place the magnetic steel base of
the DAB/DAB+ antenna on the surface
you selected. The magnetic steel base will
stick to any metallic surface.
Note: Damage may be caused to the
paintwork of the car if the antenna slides
or rotates on the car surface.
4
Route the cable: Tuck the cable under
weather strip of the door and run the
cable through the passenger doorway
or tailgate. Reserve enough slack in
your cable to fit open doors or deck
lids. Secure cables to avoid cable being
pinched between hinges and the door.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from heat,
•
sunshine or fire. Never discard batteries in fire.
Risk of decreased battery life! Never mix
•
different brands or types of batteries.
Risk of product damage! When the remote
•
control is not used for long periods, remove
the batteries.
Perchlorate Material - special handling may
•
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
For first-time use:
English
EN