Planet Technology Wireless Access Point w/Bridge WAP-1963A - Manual (Page 8)

3
Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WAP-1963A.
2.1 Hardware Connection
12V DC
LAN
RESET ANT +
1. Locate an optimum location for the WAP-1963A. The best place for your WAP-1963A is
usually at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antennas to WAP-1963A. Try to place them to a position that can best cover your
wireless network. The antenna ’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WAP-1963A. Connect this WAP-1963A to your LAN switch/hub or a
single PC.
4. Plug in power adapter and connect to power source. After power on, WAP-1963A will start to
work.
Note: ONLY use the power adapter supplied with the WAP-1963A. Otherwise, the product may
be damaged.
If you want to reset your WAP-1963A to default settings, press the Reset button 5 second.
And then wait for 10 seconds for WAP-1963A restart.