Planet Technology FGSW-2620VM - Manual (Page 48)

FGSW-2620VM User’s Manual
4.3.2.2 Per Port Configuration
You can configure path cost and priority of every port.
Figure 4-3-7 SPT - Per Port Configuration interface
OObject Description
Port
Path cost The cost of the path to the other bridge from this transmitting bridge at the specified
port. Enter a number 1 through 200000000.
Priority Decide which port should be blocked by priority in LAN. Enter a number 0 through
240 in steps of 16.
Admin P2P Some of the rapid state transactions that are possible within RSTP are dependent
upon whether the Port concerned can only be connected to exactly one other
Bridge(ie., it is served by a point-to-point LAN segment), or can be connected to
two or more Bridges(i.e., it is served by a shared medium LAN segment). The
adminPointToPointMAC allow the p2p status of the link to be manipulated
adminitratively.
Admin Edge Present in implementations that support the identification of edge ports. All ports
directly connected to end stations cannot create bridging loops in the network and
can thus directly transition to forwarding, skipping the listening and learning stages.
Admin Non Stp If true, this port will not participate in RSTP.
Apply button Press the button to save the modification.
48