Planet Technology FGSW-2620VM - Manual (Page 47)

FGSW-2620VM User’s Manual
from the default to ensure that the link between switch B and switch C is the blocked link.
The Spanning-Tree Protocol (STP) is a standardized method (IEEE 802.1d) for avoiding loops in switched networks.
When STP enabled, to ensure that only one path at a time is active between any two nodes on the network. We are
recommended that you enable STP on all switches ensures a single active path on the network.
4.3.2.1 System Configuration
This section provides RSTP-System Configuration from the Switch, the screen in Figure 4-3-6 appears.
Figure 4-3-6 Spanning Tree - System Configuration interface
OObject Description
RSTP mode Disable or enable RSTP.
Priority Assign path priority number.
Max Age The maximum path age.
Hello Time The time that controls switch sends out the BPDU packet to check STP current
status.
Forward Delay Time Forward delay time.
Apply button Press the button to save the modification.
47