Patton electronic DIAMONDLINK 3201 - Manual (Page 4)

4 DiamondLink 3201 & 3241 Quick Start Guide
2.1 Connect a PC and log in
1. Using the included combination RS232/Ethernet cable and DB9-RJ45 adapter, connect a PC’s serial port
to the on the DiamondLink’s (red)
Console port (see figure 2 ).
Figure 2. Connecting DiamondLink to the PC’s serial port
2. Start a HyperTerminal session on the PC using the settings:
9600 bps, 8 data bits, 1 stop bit, no parity, no flow control
3. Log in to the DiamondLink using the factory-default login and password:
Login: superuser
Password: superuser
Login successful
2.2 Modify the IP address
1. Display current IP interface settings for the DiamondLink Ethernet LAN port.
→ → → →
ip list interfaces
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
---|------|----------------|----------|--------------
1 | ip1 | 192.168.200.10 | disabled |
---------------------------------------------- ------
2. Modify the IP address for the LAN port according to your network requirements.
→ → → →
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
Note The above IP address ( 10.10.10.5/24) is only an example. You must choose an IP address on the same
subnet as your PC .
3. Verify the new address is correct and save it in system boot memory.
→ → → →
ip list interfaces
→ → → →
system config save
→ → → →
Power
Console
Ethernet
Line
MDI-X
Connect to Console port
(red port)
Serial port
PC with
terminal emulator