Philips 20PV230/07 - Manual (Page 11)

Initial installation
a After you have connected the aerial, confirm the picture
on the TV screen with
OK on the remote control.
’Autoinstall’ starts. This picture will appear on the screen:
AUTO INSTALL
SEARCHING
ƒƒƒƒƒƒƒ__________________
PLEASE WAIT...
Wait until all TV channels have been found. This can take
several minutes.
b When Autoinstall is complete, ’STORED’ will briefly
appear on the TV screen.
The initial installation is now complete.
D If ’YEAR’, ’MONTH’, ’DATE’, ’TIME’, appear on the
screen, date/time could not be transferred from the
teletext information.
Change the data using the number buttons
0..9 on
the remote control.
Select the lines using
=P r or ;P q .
When all information is correct, confirm with OK .
D If you have connected a satellite receiver, please
read the section ’satellite receiver’.
D If you have connected a decoder, you must install it
as described in the next section.
Allocating a decoder
Some TV stations will send coded TV channels, that you can
only watch when you use a purchased or hired decoder. You
can connect such a decoder (descrambler) to your TV-Video
Combi. With the following function, the connected decoder
will automatically be activated for the TV channel you want to
watch.
a Select the TV channel for which you want to use the
decoder with the
;P q , =P r button on the
TV-Video Combi or the number buttons 0..9 on the
remote control.
b Press the MENU button on the remote control. The main
menu will appear.
c Select the line ’MANUAL SEARCH’ with the menu
buttons
;P q or =P r and confirm with the
SqP button.
MANUAL SEARCH
PROGRAMME NUMBER W P01 X
FREQUENCY 754
DECODER OFF
EXIT: MENU STORE: OK
d Select the line ’DECODER’ with the menu buttons
=P r or ;P q .
e Select ’ON’ with the menu buttons QSr or
SqP .
D When you select ’OFF’, the decoder will not be
allocated.
f Confirm with the OK button.
g To end, press the MENU button.
Your decoder has now been allocated to this TV channel.
Manual TV channel search
In certain cases the ’Automatic TV channel search’ may not be
able to find all of the TV channels (e.g. coded TV channels). In
that case, use this manual method to set the channels.
a Press the MENU button on the remote control. The main
menu will appear.
2. INSTALLATION
7