Bluetooth setting, Pair and use a bluetooth audio accessory, Bluetooth headset – Philips Fisio 825 User Manual
Page 73: Pairing process, Bluetooth headset pairing process

71
Bluetooth
features
Bluetooth setting
This menu allows you to set and manage the options relating to Bluetooth. In
order to communicate with the different wireless devices you will be using,
Bluetooth must be set in stand-by mode. To change the default value of the
stand-by duration time (set to 15 mn), proceed as follows:
1
Press
C
and select
Buetooth
,
Bluetooth Setting
,
Bluetooth On/Off
and
press
,
.
2
Press
4
or
6
to change the duration time and set it either to
Off
,
15 mn
,
1 hour
or
Always on
. Then press
,
to confirm.
When the stand-by duration time is over, stand-by mode is automatically
reactivated when receiving a call or by pressing the configured hotkey (see
“Hotkeys” page 32).
L
Your mobile phone will NOT answer the Bluetooth connection requests of
wireless devices and accessories if the stand-by duration time is set to
Off
. We
advise you to turn Bluetooth
Off
when not using it, as it increases energy
consumption.
Pair and use a Bluetooth audio accessory
Bluetooth headset
This menu allows you to launch the pairing process with a Bluetooth headset.
Bluetooth devices must first be paired to each other (e.g the headset to your
mobile phone) before being used together; this process must be performed at
least once for two specific devices to communicate and is described below.
Pairing process
1
Turn both the mobile phone and the headset on and place them near each
other (refer to the headset documentation for information on pairing).
L
When turned on, the headset beeps or flashes. We recommend that you do not
wear the headset on your ear while proceeding with authentification process.
2
Press
C
on your mobile phone and select
Bluetooth
,
Bluetooth Settings
,
Bluetooth Headset
,
Detect
and press
,
. An animated icon appears on
the screen, showing that your mobile is searching the headset.
L
Pairing authentification should take place within 10 seconds. If it fails, you should
switch the headset into authentification mode again, as described above.
Bluetooth Settings
BT headset
Fisio825_GB_4311 255 53812.book Page 71 Vendredi, 18. octobre 2002 9:45 09