Installation guide, Anti-theft system, Remove the unit – Panasonic CQDF202 User Manual
Page 9: Panel removal alarm, Install removable face plate, Place the removable face plate into case

E
N
G
L
I
S
H
17
E
N
G
L
I
S
H
18
CQ-DF202W
CQ-DF202W
26
27
Installation Guide
(Continued)
Remove the removable face plate.
1 Press [OPEN]. The removable face plate will
be opened.
2 Push the face plate to the left.
3 Pull it out toward you.
1
2
Remove the Unit
Lock lever
8 Trim plate
SOURCE
REP
45W
X
4
RANDOM
OPEN
[OPEN]
PWR
Remove the trim plate 8 with a screwdriver.
Pull out the unit while pushing down the lock
lever with a screwdriver.
Remove the unit pulling with both hands.
1
1 Open
2 Push
3 Pull out
Contact
Main unit
Lock lever
Screwdriver
2
3
4
Switch off the power of the unit.
Anti-Theft System
Panel Removal Alarm
This alarm sounds to warn you not to forget to re-
move the panel before leaving your car.
Press and hold [SEL] to turn the panel removal
alarm on or off. (“ALRM On” or “ALRM OFF”)
Install Removable Face Plate
1 Fit the face plate with its left hole on one of the
pins provided on the main unit.
2 Fit the other hold on the other pin applying
slight pressure.
3 Move the face plate up and down a few times to
make sure it is secure. Then close the front
panel and press down the right side of the face
plate until it clicks into plate.
Caution:
≥
This face plate is not waterproof. Do not expose it to water or excessive moisture.
≥
Do not remove the face plate while driving your car.
≥
Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level.
≥
Do not touch the contacts on the face plate or the main unit, since this may result in poor electrical con-
tacts.
≥
If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.
≥
Do not apply a strong downward force onto the face plate and do not put anything on it while it is open, or
it might be damaged.
This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable.
Place the Removable Face
Plate into Case
1 Switch off the power of the unit.
2 Remove the removable face plate. (
➡
page 26)
3 Gently press the bottom of the case and open
the cover. Place the face plate into the case and
take it with you when you leave the car.
2
1
3
7 Removable face plate case
Contact
Default