Panasonic SCPM533 - Manual (Page 9)

RQTV0097
9
ENGLISH
English
English
Cassette tape
Cassette lid
Top of unit
The buttons described for “Cassette tape” are mainly
for the main unit unless indicated otherwise.
Basic play Basic play
1 Press [ 0] and insert the cassette.
" Insert inside
the guides
Forward side
2 Close the lid by hand.
3 Press [TAPE 3] to start play.
To play the other side of the cassette, turn the cassette over.
To Action
stop tape playback Press [–DEMO, 7].
start one-touch play Press [TAPE 3] when the unit is OFF with
the cassette loaded.
fast-forward and
rewind Press [4/REW/4] or [3/FF/¢] in the
stop mode.
Note
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Endless tapes can get caught up in the deckʼs moving parts if used
incorrectly.
TPS (Tape Program Sensor) TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [4/REW/4] or [3/FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
• with short silent parts
• when noise occurs between tunes
• if silent parts found within tunes
Recording Recording
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind the leader tape so that recording can begin
immediately.
Recording the radio Recording the radio
1 Insert the cassette to be recorded.
2 Tune to the required station (refer to page 10).
3 Press [ ¶ REC/8] to start recording.
Recording discs Recording discs
1 Insert the cassette to be recorded.
2 Press [CD 6] and then [–DEMO, 7].
3 Press [OPEN/CLOSE 0] to insert the disc. Press
again to close.
4 Press [PLAY MODE] on the remote control to select
your desired mode (refer to page 7).
5 Press [ ¶ REC/8] to start recording.
Recording programmed tracks Recording programmed tracks
1 Insert the cassette to be recorded.
2 Program the tracks you want (refer to page 8).
3 Press [ ¶ REC/8] to start recording.
Other basic operations Other basic operations
To Action
erase a recorded
sound 1) Insert the cassette to be recorded.
2) Press [TAPE
3] and then [–DEMO, 7].
3) Press [ ¶ REC¥8].
stop recording Press [–DEMO, 7].
stop recording
temporarily 1) Press [ ¶ REC¥8].
2) Press again to resume recording.
record on the other
side of the tape Turn the cassette over and press
[
¶ REC¥8].
You can perform the same operation of [ ¶ REC¥8] on the
main unit by pressing [REC ¶¥8] and [TAPE] simultaneously
on the remote control.
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for
side A
Tab for
side B
To re-record
Normal tape
Adhesive tape
RQTV0097_2P_EN.indd 9 RQTV0097_2P_EN.indd 9 2/6/06 3:34:48 PM 2/6/06 3:34:48 PM