Philips DCM105 - Manual (Page 14)

15
10 Other features
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1
When the unit is turned on, press SLEEP/
TIMER repeatedly to select a set period
of time (in minutes).
When sleep timer is activated, the
»
display shows .
To deactivate sleep timer
1
Press SLEEP/TIMER repeatedly until
[OFF] is displayed.
When sleep timer is deactivated,
»
disappears on the display.
Set the alarm timer
This unit can be used as an alarm clock. The
DISC, TUNER or iPod source is activated to
play at a preset time.
1
Ensure that you have set the clock
correctly.
2
In the standby mode, press and hold
SLEEP/TIMER.
3
Press DISC , TUN or iPod to select a
source.
4
Press SLEEP/TIMER WRFRQÀUP
The hour digits are displayed and begin
»
to blink.
5
Press / to set the hour.
6
Press SLEEP/TIMER WRFRQÀUP
The minute digits are displayed and
»
begin to blink.
7
Press / to set the minute.
8
Press SLEEP/TIMER WRFRQÀUP
The timer is set and activated.
»
Program radio stations
manually
Note
You can program a maximum of 40 preset ‡
radio stations.
1
Tune to a radio station.
2
Press PROG to activate program mode.
[PROG] (program) blinks on the
»
display.
3
Press PRESET +/- to allocate a number
(1 to 20) to this radio station, then press
PROG
WRFRQÀUP
The preset number and the frequency
»
of the preset station are displayed.
4
Repeat the above steps to program other
stations.
Note
To overwrite a programmed station, store ‡
another station in its place.
Select a preset radio station
1
Press PRESET +/- to select a preset
number.
Tip
)0DQWHQQDLVÀ[HGWRWKHPDLQXQLW ‡
Position the antenna as far as possible from ‡
TV, VCR or other radiation source.
For optimal reception, fully extend and adjust
‡
the position of the antenna.
English
EN