Paxar 9854 User Manual
Page 4
05/08 Rev. AB
OPERATOR’S HANDBOOK
Safety
General safety notes
«
Keep these operating instructions in a safe place and make sure they are
read.
«
The printer must be operated, adjusted and serviced by instructed and
authorized personnel.
«
Carefully follow all procedures listed in this manual.
Service
Special servicing, error searching and error correction are to be performed by
authorized personnel.
CAUTION! - The printer operates safely when you observe all necessary
information.
«
Proper operation of the product requires the user to read and follow these
operating instructions. The warranty does not cover service required as a
result of operator error and/or failure to read and follow the documentation.
WARNING! - Any changes or modifications not expressly approved by us
could void the user's authority to operate the equipment.
«
Only operate the printer using the system voltage indicated on the
nameplate!
«
Only connect the printer to a grounded power outlet.
«
Only use the printer within specified environmental conditions!
«
Only operate the printer when the cover is closed!
«
Only trained and authorized personnel should operate the printer!
«
During operation, the printhead can become hot! Be careful when touching
the printhead!
«
Do not make any modifications to the printer!
«
Do not spill any liquids into the printer!
«
Repairs to the device must be performed by authorized specialists!
«
Before cleaning the printer, turn off the printer and disconnect the power
supply!
«
Only use original accessories!
«
Connect the printer only to other devices that fulfil SELV (safety extra-low
voltage) circuit requirements to EN 60950!
Keep long hair, loose jewelry, long sleeves, etc. away from the printer
during operation.
«
Wear sufficient personal protection gear.
The printer can only be disconnected completely by removing the power
supply cable. For this reason:
«
Make sure that the printer’s power supply socket is readily accessible!
«
In case of emergency, turn off the printer and disconnect the power supply
cable!