Paxar 9854 - Manual (Page 25)

05/08 Rev. AB OPERATOR’S HANDBOOK Getting Started
9844/9854
1-17
•
Access the parameter menu:
•
Feed material until the next punch (die cut) is reached or when the button is
held down:
•
Setting the label length automatically:
After pressing the two buttons, the printer feeds the label material, until two
punches have passed the label sensor. The measured label length is
displayed and saved into parameter PRINT PARAMETERS > Material length. Next,
the parameter PRINT PARAMETERS > Material type is set to “punched.”
¯ The label length measured by this function is from label end to label end.
If material with very large punches is used, this measurement does not work
properly. In this case, measure and set the label length manually (label length
+ punch length).
Online Operation
Press the buttons indicated in black to perform the listed functions.
•
Switching to offline mode:
•
Setting the print contrast: Press Feed to increase and Cut to decrease the
print contrast.
•
Interrupting the print job: The printer finishes printing the current label.
•
Switching to offline mode while the print job is stopped:
OFFLINE x JOBS PRINT INFO
OFFLINE x JOBS OFFLINE x JOBS
feeding…
OFFLINE x JOBS OFFLINE x JOBS
Manual Calibrate
OFFLINE x JOBS
198.5 mm Displays the measured label length.
ONLINE x JOBS OFFLINE x JOBS
ONLINE x JOBS Print contrast
xxx%
ONLINE X JOBS
Restcount XXX ONLINE X JOBS
Stopped XXX
a
a) The message “Stopped xxx” alternates with “Press Feed.”
ONLINE X JOBS
Stopped XXX OFFLINE x JOBS
Prog
Feed
Feed Prog
Online
Prog
Prog
Online