Panasonic NV-MV15 EN - Manual (Page 10)

Recording
REC
OSD/DISPLAY
SP/LP/EP
Set the TV set to the video channel and insert a cassette into the video recorder;
make sure that the cassette's protection tab is still in.
! Select a channel to record from.
Select the AV channel if you are recording via the 21-pin scart cable.
! Press to start recording.
! Press the Stop button to stop recording.
! To pause recording:
The function will switch itself off after approx. 5 minutes to protect the video heads.
! To resume recording:
REC
SP : normal recording time - optimal picture quality
LP : double recording time - simple picture quality
EP : triple recording time - reduced picture quality
The display of the video recorder shows: time - counter - tape remain.
The start of a cassette is indicated as -----.
Press until ' is displayed. ! OSD/DISPLAY RE'
D When you play back LP or EP recordings, some cassettes (e.g. type)
may produce interference. This is not indicative of a malfunction.
E-300
Tape Remain counter/indicator
SV120 HV60 HV65 HV55 HV50 MV20 MV15
SV120 HV60 HV65 HV55 HV50 MV20 MV15
SV120 HV60 HV65 HV55 HV50 MV20 MV15
! Prior to starting the recording session, press to set the tape speed. SP/LP/EP
VCR
SP
VCR
SP
D Recordings in the S-VHS or S-VHS ET REC mode are supported by the PAL
TV system only. (Only SV120, page 23)
10