Initial settings, Clock set, Adjusting initial settings – Pioneer DEH P4500MP User Manual

Page 35: Setting the clock, Switching the warning tone, Switching the auxiliary setting

Adjusting initial settings

Initial settings lets you perform initial set up of

different settings for this unit.

1 Function display

Shows the function status.

1 Press SOURCE and hold until the unit

turns off.

2 Press FUNCTION and hold until the

clock appears in the display.

3 Press FUNCTION to select one of the in-

itial settings.

Press FUNCTION repeatedly to switch be-

tween the following settings:

ClockWARN (warning tone)AUX (auxili-

ary input)

Use the following instructions to operate each

particular setting.

# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down FUNCTION until the unit turns off.

Setting the clock

Use these instructions to set the clock.

1 Press FUNCTION to select clock.

Press FUNCTION repeatedly until clock ap-

pears in the display.

2 Press c or d to select the segment of

the clock display you wish to set.

Pressing c or d will select one segment of the

clock display:

HourMinute

As you select segments of the clock display

the segment selected will blink.

3 Press a or b to set the clock.

Pressing a will increase the selected hour or

minute. Pressing b will decrease the selected

hour or minute.

Switching the warning tone

If the front panel is not detached from the

head unit within five seconds of turning off the

ignition, a warning tone will sound. You can

turn off the warning tone.

1 Press FUNCTION to select WARN.

Press FUNCTION repeatedly until WARN ap-

pears in the display.

2 Press a or b to turn WARN on or off.

Pressing a or b will turn WARN on or off and

that status will be displayed (e.g.,

WARN :ON).

Switching the auxiliary setting

It is possible to use auxiliary equipment with

this unit. Activate the auxiliary setting when

using auxiliary equipment connected to this

unit.

1 Press FUNCTION to select AUX.

Press FUNCTION repeatedly until AUX ap-

pears in the display.

2 Press a or b to turn AUX on or off.

Pressing a or b will turn AUX on or off and

that status will be displayed (e.g.,

AUX :ON).

Initial Settings

English

Section

HHHHHHHHHHHHHH