Patton electronic COPPERLINK 2160 - Manual (Page 97)

Administration Command Menu 97
Model 2160 Series User Manual 5 • Console and Telnet configuration
-----------------------------------------------------------------------------
Command: admin security ip_pool modify <1~16>
Message: Please input the following information.
Client address pool entry number <1~16>: 1
Client IP address (ENTER for default) <0.0.0.0>:
-----------------------------------------------------------------------------
You can configure up to sixteen entries for legal address pools. Use the clear command to remove a legal client
IP address from any pool entry number. Use the list command to view information for all of the security pro-
files, including the Telnet TCP port and the legal IP addresses.
SNMP
Simple Network Management Protocol (SNMP) provides the exchange of messages between a network man-
agement client and a network management agent for remote management of network nodes. These messages
contain requests to get and set variables that exist in network nodes in order to obtain statistics, set configura-
tion parameters, and monitor network events. SNMP communications can occur over the LAN or WAN con-
nection.
The Model 2160 can generate SNMP traps to indicate alarm conditions, and it relies on SNMP community
strings to implement SNMP security. This Model 2160 support both MIB I and MIB II.
The snmp command menu lists commands for configuring SNMP communities and traps. Move the cursor “
>>” to snmp in the admin menu and press Enter. The following menu displays:
Community
To set up SNMP communities, move the cursor “ >>” to community in the snmp menu and press Enter. You
can configure five community entries.
----------------------------------------------------------------------
Command: admin snmp community <1~5>
Message: Please input the following information.
Community entry number <1~5> : 2
----------------------------------------------------------------------
The following menu displays:
Select edit and press Enter.
>> community Configure community parameter
trap Configure trap host parameter
>> edit Edit community entry
list Show community configuration