Pantech WV-NW474S User Manual

Page 9

-9-

!7 Set button (SET)

Validates the selection or opens a detailed menu.

!8 DIP switch

Specifies certain settings shown in the figure. The
default setting is marked with an asterisk *.
Note: The settings will be applied to the camera

only when DIP SW, not MENU, is selected in the
menu setup.

!9 Monitor output jack

Connects to the LCD monitor and other devices with
a 3.5 diam. 2-pole L-type plug for checking images.

@0 Dome cover

@1 Network port

Connects to a PC or a network via a hub with a
10BASE-T/100BASETX cable.

@2 Video output connector

Connects to the video input terminal of the monitor
or recorder.

@3 Control connector

Connects respective devices. See Connections and
Specifications for details.
Day/night in: Optical sensor
Alarm in: Door switch
Alarm out: Buzzer
AUX out: Illumination
GND: Signal ground

@4 Power cable

Supplies power to the camera. The black and white
wires are connected only when the optional heater is
built into the camera.

@5 Camera mounting bracket

@6 Cable access hole

@7 Sideway cable exit

B/W

Aperture

Upside

Sync

level

Down

High*

AUTO1

Soft

OFF

Low

OFF*

Sharp*

OFF*

INT*

@6
@7