Pantech WV-NW474S - Manual (Page 39)

-39-
■ User Setup
1. Open the User Setup window.
2. User Registration
• Enter the user name in up to 16 characters. The
default setting is "admin". Only one administrator
is necessary.
• Enter the password. The default setting is a
blank.
• Enter a password again.
• Select an access level, and click the [SET] but-
ton.
1 (Administrator): Allows you to operate setup
menus and to view live and recorded images.
2 (Camera Adjustment): Allows you to make
camera adjustments and to view live and
recorded images.
3 (Live Only): Allows you to view live and
recorded images.
Note: Blank spaces and certain symbols cannot
be used in a password.
3. User Authentication
• Select ON or OFF, and click the [SET] button.
ON: applies the user authentication.
OFF: does not apply.
• Click the [DEL] button after selecting an unwant-
ed user name to cancel it.
Note: The registered defaults admin and level 1
cannot be changed while password entry is
enabled.
4. Delete User
• Click the [DEL] button after selecting the user
name to be deleted if necessary.
Note: The registered defaults admin and level 1
cannot be changed while password entry is
enabled.
Be sure to first set the admin password. No
default password is registered.
• All users will become level 3 if both the host and
the user authentications are set to OFF.
■ Host Setup
1. Open the Host Setup window.
2. Host Authentication
• Select [ON] or [OFF] and click the [SET] button.
ON: Applies the host authentication.
OFF: Does not apply.
3. Host Registration
• Enter the IP address of the PC.
• Select an access level, and click the [SET] but-
ton. The default setting is level 1.
1 (Administrator): Allows you to operate setup
menus and to view live and recorded images.
2 (Camera Adjustment): Allows you to operate
camera adjustments and to view live and
recorded images.
3 (Live Only): Allows you to view live and
recorded images.
4. Delete Host
• Click [DEL] button after selecting an unwanted
host name to delete it.
Notes:
• Host authentication is carried out first followed by
user authentication if both are set to ON.
• All users will become level 3 if both the host and
user authentications are set to OFF.
• An unregistered host will be unable to access
the camera.
• Never turn around the order: start with the host
registration, and then proceed to authentication
ON/OFF.