Pantech WV-NW474S - Manual (Page 28)

Opening the camera setup menu
■ Camera Setup Menu (CAM
SETUP)
1. Camera Identification (CAMERA ID) Setting
You can assign a name to the camera. The camera ID
consists of up to 16 alphanumeric characters. The
camera ID display can be switched on and off on the
monitor screen.
-28-
SETTING PROCEDURES
The following pages describe setting operations from the camera.
For accessing from the PC, interpret these instructions as follows.
Escaping from the VMD mask setup
etc.
Function
Closing the camera setup menu
Opening a more detailed setup
menu
Returning to the previous menu
Opening the special menu
Resetting the parameter of an item
Resetting all the settings
Selecting an item
Selecting a parameter
Validating the selection
Hold down the [SET] button for 2 seconds.
Press the [SET] button while the cursor is
at END.
Press the [SET] button while the cursor is
at an item tailed with
O mark.
Press the [SET] button while the cursor is
at RET.
Hold down the [Left] and [Right] buttons
simultaneously while the cursor is at RET
in CAM SETUP.
Hold down the [Left] and [Right] buttons
simultaneously while the cursor is at the
item.
Hold down the [Left] and [Right] buttons
simultaneously while the cursor is at CAM-
ERA RESET.
Press the [Up] or [Down] button.
Press the [Left] and [Right] button.
Press the [SET] button.
Hold down the [SET] button for 2 seconds.
Click the Camera Setup button in the
main page to display the menu control
buttons.
Click the [MENU ON] button.
Click the [MENU OFF] button.
Click the [SET] button while the cursor is
at the item tailed with
O mark.
Click the [SET] button while the cursor is
at RET or simply clock the [ESC] button.
Click the [RESET/SPECIAL] button while
the cursor is at RET in CAM SETUP.
Click the [RESET/SPECIAL] button while
the cursor is at the item.
Click the [ALL RESET] button while the
cursor is at CAMERA RESET.
Click the [D] or [C] button.
Click the [A] or [B] button.
Click the [SET] button.
Click the [ESC] button.
From the Camera From the PC
■ Setup Selection
1. Move the cursor to CAMERA or NETWORK, and
press [SET] to open the desired setup menu.
CAMERA
N: Opens the CAMERA SETUP menu.
NETWORK
N: Opens the NETWORK SETUP menu.
2. Move the cursor to END, and press [SET] to return
to camera image screen.
Note: When SETUP DISABLE appears in the bot-
tom line you cannot change the currently active
settings. This disablement is designed to pre-
vent accidental setting change. Refer to the pre-
vious page to change it to ENABLE.
** SET UP **
CAMERA
NETWORK
END SET UP DISABLE
↵
↵
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE
POSI RET END RESET
................
Character Cursor
Cursor
Character
Area
Command
Editing
Area
CAMERA ID menu
** CAM SET UP **
CAMERA ID OFF
ALC ALC
SHUTTER ---
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
MENU
RET END
↵
↵↵