Panasonic PV C2033W - Manual (Page 32)

32 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected] 32 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
REC 1 2 : 0 0PM
0 : 25 CH08
-0 : 1 2 : 3 4
SP
NO V-CHIP DATA
Warning and Instruction Displays These displays will alert you to a missed
operation or provide further instructions.
Press DISPLAY to display or remove
the overlay. Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Weak Signal Display set
to “OFF” (see page 28), the screen will turn solid
blue.
When a function button is pressed (PLAY, FF, etc.)
or you change channels, the unit mode or channel
number will be displayed.
CH 08
Function Status
Current Time
Rec Time
Remaining
(OTR mode
only, see
page 12.)
Counter
Tape Speed
Channel
VCR Status & Clock Display Blue Screen Display
Channel & Function Display
On-Screen Display (OSD)
OSD CAUTION Page
PLEASE SET CLOCK BY
PRESSING ACTION KEY If you attempt to set or review a Timer Recording, or
set the On-Timer and the Clock is not set...
8 - 11
CHECK CASSETTE RECORD TAB
If you press REC, and a cassette is inserted with no
record tab...
3, 12
TO CANCEL TIMER REC HOLD
DOWN STOP KEY FOR APPROX 3
SEC
If you press STOP during a Timer Recording... 23
NO CASSETTE
If you press PLAY, FF, REW, or REC without a
cassette inserted...
12
PLEASE PREPARE FOR TIM ER
REC
If the unit is not in Stop mode or a cassette with
record tab is not inserted two minutes before a Timer
Recording is about to begin...
22 - 23
VIDEO HEADS MAY NEED
CLEANING PLEASE INSERT HEAD
CLEANING CASSETTE OR REFER
TO MANUAL END: PLAY
If head cleaning becomes necessary while playing
back a tape...
4
VCR LOCK ACTIVATED
If you press a function button other than STOP/EJECT or
POWER while the unit is in VCR Lock mode...
28