Philips UCZZ01927AB - Manual (Page 36)

34 Frequently asked questions
9.1 Connection
The handset does not switch on!
• Charge the batteries: Put the handset
on the base station to charge. After a
few moments, the phone will switch
on.
The handset does not charge!
• Check charger connections.
icon is not blinking during
charge!
• Battery is full: There is no need to
charge the battery.
• Bad battery contact: Adjust the
handset slightly.
• Dirty contact: Clean the batteries
contact with a cloth moistened with
alcohol.
Communication is lost during a call!
• Charge the battery
• Move closer to the base station.
The phone is “Out of range”!
• Move closer to the base station.
9.2 Set-up
SEARCHING is displayed on
handset and
icon is blinking!
• Move closer to the base station.
• Make sure that your base station is
on.
• Reset your unit and restart handset
registration.
9.3 Sound
Handset does not ring!
Check that the RING VOLUME is not
set to RINGER OFF, and make sure
the
icon is not displayed on the
screen (see “Set the Ring Volume” on
page 27).
Caller does not hear me!
Microphone may be muted: During a call,
press
s.
There’s no dialling tone!
• No power: Check the connections.
• Batteries are empty: Charge the
batteries.
• Move closer to the base station.
• Wrong line cord used: Use the line
cord provided.
• Line adaptor may be required: If
applicable, connect the line adaptor to
the line cord.
Caller does not hear me clearly!
• Move closer to the base station.
• Move the base station at least one
metre away from any electronic
appliances.
Frequent noise interference on my
radio or television!
• Move the base station as far away as
possible from the electrical appliances.