Philips UCZZ01927AB - Manual (Page 33)

31 Advanced settings
Upon reset, all your personal settings,
call log and redial list entries will be
deleted and the phone will return to its
default settings. However, your
phonebook will remain unchanged after
reset.
You may have to configure your phone
once again. In this case the WELCOME
mode will appear again after reset. (Go
to chapter 3.3)
1
Press
m in idle mode, scroll n to
ADVANCED SET and press
o,
scroll
n to RESET and press o.
2
CONFIRM? is displayed on the
screen.
3
Press
o again to confirm.
• A validation tone is emitted.
• The unit is reset to its default
settings. (See “Default settings”
on page 32)
7.6 Set Prefix
This feature allows you to define a prefix
number to be added to the beginning of a
number during predialling (see
“Predialling” on page 17). You may also
use this feature to add a detect string to
match and replace the first few digits of
the number during predialling.
You can enter up to a maximum of 5
digits for the detect string and 10 digits
for the auto prefix number.
1
Press
m in idle mode, scroll n to
ADVANCED SET and press
o,
scroll
n to AUTO PREFIX and
press
o.
2
DETECT DIGIT is displayed on
the screen. Press
o to enter.
• The last stored detect string is
displayed (if any).
3
Enter a detect string number
(maximum 5 digits) and press
o
to confirm.
4
PREFIX is displayed on the screen.
Press
o to enter.
• The last stored prefix number is
displayed (if any).
5
Enter the prefix number (maximum
10 digits) and press
o to confirm.
• SAVED is displayed and the
screen returns to idle screen.
If no detect string (blank) is entered, the
prefix number will be automatically
added to the predial number after
t is
pressed.
For numbers starting with *, # or P, the
prefix number will not be added to the
predial number after
t is pressed.
7.7 Change Recall time
Recall time (or dial delay) is the time
delay by which the line will be
disconnected after you press
t key. It
can be set to short or long.
The default value of recall time that is
preset in your handset should be the best
suited for your country network and
therefore you should not need to change
it.
1
Press
m in idle mode, scroll n to
ADVANCED SET and press
o.
2
Scroll
n to RECALL TIME and
press
o
Warning
Note
Note