Polycom RMX 2000 - Manual (Page 31)

Polycom RMX 2000 Hardware Guide
1-25
Replacing the RTM IP Board
The RTM IP board on the rear of the RMX 2000 provides connectivity to
all the MCU modules. Use the following procedure to replace the RTM IP
board:
1
Ensure that power switch to the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws on the rear panel of the RMX 2000 that
secure the RTM IP board.
3 Use the metal ejector levers to pull the RTM IP board out of its slot in
the Backplane.
4 Carefully slide the RTM IP board out through the rear panel.
5 On the card to be installed, move the ejector levers to their fully open
position.
6 Slide in the replacement RTM IP board.
7 Push the RTM IP board firmly into the Backplane, making sure it is
properly seated in its slots.
8 Ensure that the metal ejector levers are fully retracted into their
housings.
9 Tighten the captive screws on the rear panel of the RMX 2000 that
secure the RTM IP board.
10 Turn ON the RMX 2000.