Polycom RMX 2000 - Manual (Page 27)

Polycom RMX 2000 Hardware Guide
1-21
Replacing the Power Supply Drawer
A single supply unit powers the RMX 2000. Use the following procedure
to replace a Power Supply:
1
Ensure that power switch to the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws on the front panel of the RMX 2000 that
secure the Power Supply.
3 Use the metal ejector levers to pull the Power Supply Module out of
its slot in the Backplane.
4 Carefully slide the Power Supply Module out through the front
panel.
5 Slide in the replacement Power Supply Module.
6 Push the Power Supply Module firmly into the Backplane, making
sure it is properly seated in its slot.
7 Ensure that the metal ejector levers are fully retracted into their
housings.
8 Tighten the captive screws on the front panel of the RMX 2000 that
secure the Power Supply Module.
9 Turn ON the RMX 2000.