Polycom RMX 2000 - Manual (Page 22)

Chapter 1- Hardware Description
1-16
Component Replacement
The RMX 2000 is designed with ease of maintenance in mind. Most
components are swappable and are accessible directly via the front panel
or the rear panel.
The following components can be replaced when they are faulty:
•
CPU (CNTL) Module
• Multi Processor Module (MPM) Board(s) - This board is Hotswap
enabled
• Power Supply Module
• Fan Drawer
• RTM IP Board
Before replacing parts:
•
To ensure a part needs replacing, complete the troubleshooting
procedures.
• Identify exactly which part needs replacing.
• Make sure you have the correct replacement part on hand.
• Make sure you are using proper ESD equipment, to prevent damage
to the system.
Hot Swappable MPM Boards
All MPM Boards can be installed or removed while the RMX 2000 is
powered on and operating.
Warning!
• All maintenance tasks are to be performed by qualified, authorized
personnel.
• Use only replacement parts supplied by your dealer.
• Follow all procedures. Do not skip any steps.
The RTM IP and RTM ISDN Card are not Hotswappable. System shutdown is
required when replacing the ISDN or IP RTM card.