Plantronics CT10 - Manual (Page 13)

8
Put on the Headset , and adjust the band until it rests with almost no
pressure on your ear and the top of your head.
If the headset is too loose, remove it and gently push the headset band
inward slightly to tighten it. If the headset is tight, gently pull the headset
band out to loosen it.
The microphone boom can be swiveled to position the headset on either
your right or left ear by rotating it up over the head.
Use one hand to hold the headset in place. Adjust the microphone boom
until it is about 1 inch from the side of your mouth. Do not twist the
microphone on the end of the boom as this may damage the internal
wiring.
Use the Clothing Clip to attach the headset cord to your lapel or collar
and out of your way.
Leave enough slack in the headset cord so that you can move your head
freely.
F
SETUP THE HEADSET
The Pulse/Tone Switch is located under the Base simply push the
switch to Pulse or Tone as desired or required by your telephone service.
PULSE/TONE SWITCH
STEP 1
F